CFA Piles
Continuous Flight Auger piles installed in a single continuous drilling motion — a fast, efficient method suited to stable ground conditions.
Our Services
Comprehensive Foundation & Geotechnical Solutions
SAEC delivers a wide spectrum of specialized foundation engineering, geotechnical, and structural repair services designed to meet complex project requirements across the UAE.
Bored Piles
Piles installed using steel casing to support the borehole in loose, unstable, or water-bearing ground — used for larger diameters and greater depths.
Micro Piles
Small-diameter piles for underpinning, slope stabilization, and restricted access sites.
Foundation Rehabilitation
Restoring and strengthening existing foundations to extend service life.
Pile Design
Engineering design and analysis of pile foundations using advanced geotechnical software.
Debonding Piles
Piles designed with a debonded upper section to reduce load transfer to specific soil layers, used where controlled settlement or reduced friction is structurally required.
Anchoring
Ground anchors installed to provide tension resistance, supporting structures against uplift, lateral loads, or slope movement.
Grouting
Pressure grouting techniques used to strengthen soils, fill voids, control groundwater, and improve foundation performance.
Controlled Modulus Columns (CMC)
Semi-rigid column inclusions installed into weak soils to improve bearing capacity and reduce settlement, without soil displacement or vibration.
Secant Piles
Interlocking secant pile walls for groundwater control and earth retention.
Sheet Piling
Steel sheet pile installation for temporary and permanent earth retention.
Berlin Wall System (Soldier Piles)
A shoring method using vertical steel soldier piles with horizontal timber or concrete lagging between them, commonly used for temporary excavation support.
Static Load Test – Crown Reaction System
Static axial compression testing using a steel crown/reaction frame supported by reaction piles or anchors.
Static Load Test – Kentledge System
Static axial compression testing using kentledge weights as the reaction system to determine pile load capacity and settlement.
Bi-Directional Static Load Test – O-Cell System
Static pile load testing using an embedded hydraulic O-cell to evaluate shaft and base resistance independently and determine load-bearing capacity.
Dynamic Load Test (PDA)
High-strain dynamic impact testing used to evaluate pile capacity and performance.
Cross-Hole Sonic Logging (CSL)
Uses ultrasonic signals between access tubes to identify defects, voids, or poor-quality concrete in bored piles.
Thermal Integrity Profiling (TIP)
Uses heat generated during concrete hydration to assess pile integrity and identify anomalies.
Pile Sonic Echo / Low-Strain Test
A low-strain impact test that measures the reflected wave to assess pile integrity.
Pile Integrity Test (PIT)
Low-strain testing to check pile continuity and detect defects, cracks, necking, bulging, or changes in pile section.
Execution
On-The-Ground Execution
SAEC operates a comprehensive fleet of heavy and specialized equipment, enabling fully self-performed project execution with high efficiency and full control over quality, schedule, and cost. Our integrated approach ensures seamless delivery from concept to completion.
Full
In-House Execution
ISO
Certified Standards
HSE
Compliance
QA/QC
Assurance